Paper Plate - Page 2 of 11

Felt Petal Patch Builder

Steps:

Have your child choose two or three colorful sheets of felt to make their garden flowers.
Show your child how to use child-safe scissors to cut the felt into small, three-inch squares.
Ask them to fold each felt square in half.
Snip the corners to create rounded petal shapes.
Encourage your child to squeeze the hole puncher to click a hole in the center of each felt piece.
Roll a large, heavy ball of playdough using both hands.
Press it flat onto a paper plate to make a steady base.
Pick up a pipe cleaner.
Slide the felt petals onto it one by one using pinching fingers.
Push the bottom end of the pipe cleaner deep into the playdough base to plant their finished flower!

Safety Tip:
Always supervise your child closely during scissor play. Collect any small felt scraps or playdough bits immediately to prevent choking.

Yarn Ring Orbit Slider

Steps:

Use markers to draw a bright yellow sun in the very center of your paper plate.
Use the hole puncher to click four holes around the outer rim of the plate.
Use scissors to cut two pieces of yarn, each about twelve inches long.
Have your child slide three colorful beads onto each piece of yarn.
Push the ends of the yarn through the opposite holes to create two crossing tracks.
Secure the yarn ends firmly to the back of the paper plate using masking tape.
Ask your child to hold the plate steady on the table with their helper hand.
Use the pinching fingers of their other hand to slide the beads along the tracks from orbit to orbit!

Safety Tip:
Supervise your child closely when they are handling scissors, small beads, or yarn. Store all small pieces safely out of reach after play to prevent any choking hazards.

The Musical Ribbon Shaker

Steps:

Give your toddler two paper plates to decorate with markers.
Place one plate face up on the table.
Help your child pick up a handful of beans.
Ask them to use their thumb and pointer finger to drop the beans one by one.
Place the second plate upside down on top of the first.
An adult should staple the edges together firmly.
Glue several colorful ribbon strips to the sides of the shaker.
Show your toddler how to hold the shaker with both hands.
Shake the plates to the beat of your favorite song!

Safety Tip:
CHOKING HAZARD: Beans and staples are small. Always supervise your child and ensure the plates are sealed tightly.

The Ribbon Twirl Spinner

Steps:

Use the pencil to carefully poke a hole right in the center of the paper plate.
Push the pencil through the hole until the plate is near the eraser end.
Use several small pieces of masking tape to secure the plate to the pencil so it doesn’t wobble.
Cut four or five long strips of colorful ribbon using your scissors.
Tape one end of each ribbon strip to the edge of the paper plate.
Have your child hold the pencil handle with one hand while using their other hand to spin the plate.
Watch as the ribbons wrap around the pencil like a colorful twister!
Challenge them to spin it the other way to unwrap the ribbons.

Safety Tip:
Always supervise your child when they are using scissors or a pencil to ensure they stay safe.

Paper Plate Target Disc

Steps:

Use your scissors to cut three circles from a single paper plate. These are your flying discs.
Decorate each disc with bright markers to make them easy to see.
Place your laundry basket in the middle of a clear floor area.
Use masking tape to mark a start line a few feet away from the basket.
Have your child stand behind the line and hold a disc with one hand.
Show them how to hold the cardboard base steady with their other hand to act as a launch pad.
Ask them to use their index finger to flick the paper disc toward the basket.
Challenge them to get all three discs inside the basket in a row!
Move the start line further back once they become an expert launcher.

Safety Tip:
Always ensure the play area is clear of breakable items before launching your paper discs. Adult supervision is recommended to manage the use of scissors.