Sequencing - Page 4 of 10

Spiral Twist Core Threading

Steps:

Adult Step: Secure the paper roll horizontally onto the cardboard base using strong masking tape. This creates a stable ‘dowel’ for twisting.
Use the markers to draw colorful stripes or dots onto several index cards. Cut the decorated cards into long, narrow strips (about 1/2 inch wide).
Take one paper strip. Use your fingertips to curl and twist the strip tightly around itself to create a stiff, narrow spiral shape.
Secure the end of the paper spiral with a small amount of glue to keep the resistant shape from unrolling. Repeat steps 2 and 3 to make a pile of colorful spirals.
Hold the cardboard base firmly steady with your non-dominant hand. Pick up a paper spiral with your working hand.
Aim the spiral at the paper roll. Use a continuous twisting motion (like screwing in a lightbulb) to thread the spiral onto the roll, pushing it along the core.
Continue twisting and pushing the colorful spirals until the entire paper roll is covered in dense, textured art. Then, try unwinding them!

Safety Tip:
Constant adult supervision is required. Adults should manage the scissors for preparation. Ensure the child remains seated stably to focus on the fine motor movements and to prevent the board from tipping.

Felt Roll & Clip Match

Steps:

Use markers to draw a simple dot on one felt strip and a matching dot on one index card.
Place the felt strip flat. Roll the felt tightly around the pencil to create a dense, resistant cylinder.
Remove the pencil carefully while holding the felt roll firmly with your helper hand to keep the shape.
Pick up the paper clip using a strong pincer grasp (thumb and index finger).
Slide the paper clip onto the felt cylinder to secure the roll. This requires effort and focus.
Set the finished felt scroll onto the Index Card that has the matching marker dot. Repeat for all felt strips.

Safety Tip:
Constant and direct adult supervision is required. Small paper clips and felt scraps pose a potential choking hazard for children who still place objects in their mouths. Ensure all materials are collected immediately after play.

Layered Cardboard Pin Weave

Steps:

Prep the surface by taping two Index Cards tightly together. Secure this layered card firmly onto a piece of Cardboard using Masking Tape.
Use a Marker to draw 8 to 10 small target dots across the layered card. Ensure the targets are spaced out.
Challenge your child to hold the cardboard base steady with their helper hand to stabilize the work area.
Pick up one Q-Tip using a strong pincer grasp. Aim the Q-Tip at a target dot.
Use a strong, controlled push to pierce the Q-Tip completely through the resistant layered cards and into the cardboard base. This takes effort!
Once all dots are pierced, gently remove the Q-Tips. Pick up a stiff Pipe Cleaner and thread it through the newly created holes to weave a colorful pattern.

Safety Tip:
Constant and direct adult supervision is required. Q-Tips and cut pipe cleaner pieces are small materials and pose a potential choking hazard for young children. Adults should manage the scissors for preparation.

Foil Cap Tweezer Feed

Steps:

Tear the aluminum foil into small, manageable strips using both hands.
Use your fingertips to tightly crumple each strip into a dense ‘rock.’ Place these rocks in the container.
Hold the bottle firmly steady with your helper hand. Use your dominant hand to twist the cap off completely.
Pick up the tweezers. Use a precise pincer grasp to grab one tiny foil rock.
Carefully carry and drop the foil rock into the narrow bottle opening.
Twist the cap firmly back onto the bottle. Repeat the whole sequence until the bottle is full.

Safety Tip:
Constant and direct adult supervision is required. Ensure children compress the foil tightly to avoid sharp edges. Collect all small foil pieces and tweezers immediately after play, as they pose a potential choking hazard.

Corner Fold & Weave Push

Steps:

Give your child a piece of cardboard. Encourage them to use both hands to tear the cardboard into rough, postage stamp-sized pieces.
Take one torn cardboard piece. Fold a corner tightly in half, then fold it over one more time to create a dense, narrow point.
Place the finished folded pieces in the plastic container. These are your weaving targets.
Take a pipe cleaner and curl one end into a loop to create a dull ‘needle.’
Hold the folded cardboard piece firmly steady with your helper hand.
Use your dominant hand to grip the pipe cleaner needle with a strong pincer grasp. Push the needle straight through the tight folded point of the cardboard.
Repeat this process, pushing the pipe cleaner through each resistant cardboard fold.

Safety Tip:
Constant and direct adult supervision is required. Pipe cleaners are small materials and pose a choking hazard for children who still place objects in their mouths. Ensure any cut ends of the pipe cleaners are curled safely before starting the activity.