Resistant Foam Pin Push

Resistant Foam Pin Push

Steps:

  • Adult Prep: Use a marker to draw several guide dots onto the foam sheet. Use masking tape to secure the foam tightly onto the sturdy cardboard base.
  • Help your child bend or roll several pipe cleaners until they are stiff, short pieces. These are your ‘resistant pins.’
  • Ask your child to hold the cardboard base firmly steady on the table using their non-dominant (helper) hand.
  • Pick up a resistant pin using a strong pincer grasp (thumb and pointer finger).
  • Aim the tip of the pin at a marked dot. Use a controlled, strong push to drive the stiff pipe cleaner straight through the dense foam and into the cardboard base.
  • Repeat this forceful pushing action until all the marked dots have been successfully filled with colorful pins.

Safety Tip:
Constant and direct adult supervision is required. Pipe cleaners are small materials and pose a choking hazard for children under five. Ensure materials are used only as intended and collected immediately after play.

Sticky Sludge Squeeze

Sticky Sludge Squeeze

Steps:

  • Mix about half a cup of oats with a small amount of water in the plastic container. Stir until you have a thick, resistant, soupy mixture (the ‘sludge’).
  • Secure the construction paper vertically onto a wall or door using masking tape. This is your target canvas.
  • Tear off several small pieces of masking tape. Place them on the paper, sticky side facing OUT, to create a simple shape or path.
  • Hold the eyedropper using your thumb and pointer finger. Squeeze the bulb hard to draw up the resistant oat sludge.
  • Stabilize the paper with your helper hand. Aim the dropper at the sticky tape targets.
  • Squeeze the dropper forcefully to release the thick sludge onto the sticky tape. Continue this until all the sticky spots are covered.

Safety Tip:
Constant and direct adult supervision is required. Ensure the child only uses the mixture and eyedropper as intended. Oats pose a potential choking hazard if ingested.

Resistance Trace Bag

Resistance Trace Bag

Steps:

  • Adult Prep: Fill a gallon-sized Ziplock Bag halfway with corn kernels. Add a small amount of water to create a thick, dense texture that is resistant to movement.
  • Seal the bag tightly, ensuring all excess air is removed. Place the sealed bag flat inside a shallow plastic container to stabilize it on the table.
  • Use a marker to draw simple lines, letters, or shapes (like a circle or a cross) directly onto the outside of the bag.
  • Challenge your child to use only their pointer finger (finger isolation) to press hard into the bag, tracing the marker lines.
  • They must use sustained pressure to push the kernels aside, leaving a visible path in the resistant medium. This requires great effort!
  • When finished, gently shake the bag to reset the kernels. Use a damp paper towel to wipe the marker lines off the bag and start with a new shape.

Safety Tip:
Constant and direct adult supervision is required. Ensure the Ziplock Bag is sealed completely before use, as corn kernels pose a choking hazard if ingested.

Foam Fortress Pull-Apart

Foam Fortress Pull-Apart

Steps:

  • Use markers to draw simple shapes onto the foam sheets. Shapes like squares and rectangles work best for building.
  • Ask an adult to use scissors to cut the foam shapes out. Cut the craft sticks in half if needed.
  • Hold two foam pieces together so the edges align. Use a marker to dot the spot where you want to connect them.
  • Take one craft stick. Use strong finger force to push the stick straight through the marked spot, connecting the two foam pieces tightly.
  • Continue connecting pieces until you build a large structure, like a wall or a tower.
  • Now for the heavy work! Challenge your child to grab the structure with both hands. Use a strong, steady pull to separate the connected foam pieces, one stick at a time.
  • Collect all the sticks and foam pieces to build an even bigger structure next time.

Safety Tip:
Constant and direct adult supervision is required. Craft sticks are small objects and pose a potential choking hazard for young children. Adults must handle the scissors during preparation.

Plate Rim Precision Tweeze

Plate Rim Precision Tweeze

Steps:

  • Use a marker to draw several small shapes onto the flat center of the paper plate. This is your stacking zone.
  • Challenge your child to tear the rim off the paper plate. They should aim to tear the thick rim into small, rough, curved pieces. Tearing this resistant material requires strong effort.
  • Once the rim is completely torn, place the small curved pieces onto the construction paper beside the plate. This is your supply pile.
  • Ask your child to hold the paper plate steady with their non-dominant hand (the helper hand).
  • Use the tweezers to pick up one torn rim piece at a time. The child must grip the piece firmly without squeezing too hard.
  • Carefully transfer and stack the torn pieces onto the marked area in the center of the plate. Keep the stack balanced and try not to knock it over!

Safety Tip:
Constant and direct adult supervision is required. The torn paper pieces are small objects and pose a potential choking hazard for young children. Ensure the child only uses the tweezers and paper as intended.