Masking Tape - Page 13 of 25

Sticky Ribbon Rescue

Steps:

Adult Prep: Tightly wrap a piece of Yarn or Ribbon around a Craft Stick. Secure the ends of the yarn with small, strong strips of Masking Tape.
Place the finished stick and the empty Container on a stable table.
Challenge your child to hold the stick firmly with their helper hand to keep it still.
Encourage your child to use their working hand to pinch an edge of the tape. Pull the tape strip off slowly against the resistance.
Once the tape is peeled, they can unwrap the yarn and drop the ‘rescued’ ribbon into the Container. Repeat with other prepared sticks!

Safety Tip:
Ribbon, yarn, and small pieces of masking tape are choking hazards for children under three. Constant, direct adult supervision is required throughout this activity. Ensure the child remains seated and materials are not placed near the mouth.

Ribbon Slot Stuffing

Steps:

Adult Prep: Use the Scissors to cut three tight, narrow slots (about 1.5 inches long) into the Cardboard or the lid of the Container. Secure the Cardboard/lid tightly using Masking Tape.
Give the child long strips of Ribbon. Encourage them to use both hands to tear the Ribbon into small, stamp-sized pieces. Tearing wakes up the hand muscles!
Ask your child to hold the container steady with their helper hand (proximal stability) while it sits on the table.
Pick up one torn Ribbon piece. Crumple it tightly into a small ball using only their fingertips (working on pincer grasp and in-hand manipulation).
Aim the crumpled ribbon ball at a slot. Use a controlled, firm push with the index finger or thumb to send the ribbon piece completely inside the container. Repeat until the container is full!

Safety Tip:
Ribbon pieces are small objects. Constant and direct adult supervision is required throughout the activity, as they pose a choking hazard for children under five.

Resistant Rip Mural

Steps:

Secure a large sheet of cardboard vertically onto a wall or door using masking tape.
Place several long strips of masking tape horizontally across the cardboard, sticky side OUT, creating several large, sticky ‘target zones’ or frames.
Give your child a large, flat piece of thick cardboard.
Challenge your child to use both hands to tear the thick cardboard into small, jagged pieces (this requires strong effort!).
Encourage them to pick up one torn piece and firmly press it onto the vertical sticky target, filling the frames to create a textured mural.

Safety Tip:
Ensure the vertical cardboard surface is stable and cannot fall or slide during the activity. Always supervise young children to ensure they do not attempt to ingest torn cardboard or masking tape pieces.

Stick Bridge Clip

Steps:

Prep the “bridge” by using masking tape to secure 5 to 7 craft sticks in a row onto the underside of a sturdy, stable table (or a sturdy chair seat).
Place the pile of clothespins within easy reach on the floor beneath the table.
Challenge your child to lie on their back on the floor, directly under the table, facing the craft sticks. This is the starting position.
Encourage your child to reach up and squeeze open one clothespin at a time. They must aim carefully to clip the pin onto the ‘bridge’ (the craft stick).
Continue until every stick is covered in colorful clothespins. To repeat, they can clip them all off and start again!

Safety Tip:
Maintain constant adult supervision. Clothespins are small objects and pose a potential choking hazard for children who might still place items in their mouths. Ensure the table used is stable and cannot tip over during the activity.

Plate Spin Targets

Steps:

Use markers to draw 4-6 small, bright dots (targets) randomly across the surface of the paper plate.
Flip the plate over. Use masking tape to secure a craft stick firmly to the center back as a spin handle.
Have your child place the plate on the table. They use one hand to grasp the craft stick handle.
Challenge your child to spin the plate quickly using their hand (practicing forearm rotation).
While the plate is spinning, they must try to quickly tap the center of a colored dot using the pointer finger of their other hand.
Try switching hands! Use the non-dominant hand to spin and the dominant hand to tap the moving targets.

Safety Tip:
Ensure the plate and handle are securely fastened. Supervise closely to ensure the child keeps their fingers clear of the spinning parts to avoid minor scrapes.